5-103
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Creating a Method
For more information about editing these data analysis parameters, please refer to
the appropriate sections of Chapters 12-15.
The changes you make are not recorded to the method until you save the method.
4 To save the method, complete the following steps:
You must close the Data Analysis window before you can save the method.
1) Double-click the Control Box Menu in the top left corner of the Data Analy-
sis window.
The Data Analysis window closes, and ChemStation returns to the Top window.
2) Select Top
>>Methods.
The Methods menu appears.
3) Select Methods
>>Save.
The Method Save Options dialog box appears. Save the method as described in
Saving a Method and Calibration earlier in this chapter.
You can also modify this section of a method by selecting Method
>>Edit Entire
Method. Click only the Data Analysis box in the Edit Entire Method dialog box,
and click OK. When the dialog box appears, make the changes you want and click
OK. Then, complete the saving steps as described in Saving a Method and
Calibration earlier in this chapter.
To Next Page
Loading...
Need help?
General
