8-14
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Running a Sample Analysis
Proceed to step 5).
3) To set a specific value for the current sample, select the Set Specific Value radio
button.
4) Set the concentration in the Conc field in the Current ISTD Conc table.
The Current ISTD Conc table shows the internal standard currently set for
calibration.
Click on the Conc field and enter a concentration level. Click the right mouse button
to display the popup menu, which allows you to copy, paste, or delete the field.
Click Browse to set the concentration setting for each calibration level in the
Concentration field.
5) Click OK.
The Set ISTD Conc dialog box will close and the internal standard concentration
level will be set in the Start Run dialog box.
If the Select a Calibration Level radio button was selected, the level number will be
displayed. If the Set Specific Value radio button was selected, “Manual” will be
displayed.
7 Set a section in the Method Sections To Run: area.
NOTE By using the Pre-Run Macro/Cmd: or Post-Run Macro/Cmd: check boxes, it is
possible to specify whether the action is performed before or after data acquisition.
ChemStation is equipped with macros that enable automatic startup and shutdown of
the equipment. Contact your local Agilent Technologies for information on
additional customized macros.
8Click Run Method.
The analysis starts and the Run Method Status box appears. This status box remains
open during the sample run. You can view a real-time display of the run without
closing the status box. See “Monitoring a Run” later in this chapter for instructions.
NOTE The Start Run dialog box contains OK, Cancel and Help buttons.
Click OK to accept the edited information without executing the method.
Click Cancel to cancel the edited information.
To Next Page
Loading...
Need help?
General
