2-11
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Configuration
NOTE In normal use, there is no need to select Use Dead Time calibration. For more
information, see Appendix C, “Dead Time Calibration”.
Click OK when you complete the detail setting.
10 Click Save.
Save the settings and end the configuration task.
NOTE The Reset to Default, Save, Cancel, and Help buttons are displayed in the ICP-MS
Configuration dialog box. If Reset to Default is clicked, it restores the factory settings
(Except the setting of the toolbar and the QC configuration). If Cancel is clicked, it
cancels the change of setting, and ends the ICP-MS Configuration dialog box.
Open File Dialog Box
11 Click Save.
Save the settings and end the configuration task.
To Next Page
Loading...
