Agilent Technologies 7500 ICP-MS User Manual

19-33
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Installing the Agilent 7500 ChemStation Software (Windows 2000)
17 Select Start>>Programs>>ICP-MS ChemStation>>Edit hosts. Enter the IP
Address and the Host Name of Agilent 7500 which is setup in the Bootp Service.
Save the hosts file.
18 Reboot the computer.
19 Turn off the power of the Agilent 7500. Confirm the cable connection between
the Agilent 7500 and the computer. Then turn on the Agilent 7500.
CAUTION After restarting the computer, turn off and turn on the Agilent 7500.
20 Start the ICP-MS ChemStation and download the firmware.
Double click ICP-MS Top.
When the ICP-MS Top window appears, download of the firmware starts
automatically. (it takes approximately 10minutes)
21 Go to standby mode.
Select Vacuum>>Vacuum ON from the ICP-MS Instrument Control window to go
to standby mode.
CAUTION Do not specify *.B, *.D, *.M, *.C, or long file names as ChemStation installation
destinations. If these are specified, there is a possibility that the various methods,
data, data batch, and calibration can not be loaded.

Agilent Technologies 7500 ICP-MS Specifications

General

Brand	Agilent Technologies
Model	7500 ICP-MS
Category	Laboratory Equipment
Language	English