Agilent Technologies EXA N9010A - Page 43

42
Compatible SCPI Commands
SCPI Summary Table
CALCulate<1|2>:LIMit<1...8>:UPPer:SHIFt
<numeric_value>
FSE/FSP/FSU Yes The unit supported are
DBM and DB.
CALCulate<1|2>:LIMit<1...8>:UPPer:SPACing
LINear | LOGarithmic
FSE/FSP/FSU Yes
CALCulate<1|2>:LIMit<1...8>:UPPer:THReshol
d <numeric_value>
FSP/FSU Yes The only unit supported is
DBM.
CALCulate<1|2>:MARKer<1...4>[:STATe] ON |
OFF
FSE/FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:AOFF FSE/FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:TRACe 1 to 3 FSE/FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:X 0 to MAX
(frequency | sweep time)
FSE/FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:X:SLIMits[:S
TATe] ON | OFF
FSE/FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:X:SLIMits:LE
FT 0 to MAX (frequency | sweep time)
FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:X:SLIMits:RI
GHT 0 to MAX (frequency | sweep time)
FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:COUNt ON |
OFF
FSE/FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:COUNt:RESo
lution 0.1 | 1 | 10 | 100 | 1000 | 10000 Hz
FSE/FSP/FSU Yes Support the parameter
option: 1 | 10 | 100 | 1000 |
10000 | 100000 | 1000000
Hz
CALCulate<1|2>:MARKer<1...4>:COUNt:FRE
Quency?
FSE/FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:LOEXclude
ON | OFF
FSE/FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:Y? FSE/FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:Y:PERCent FSP/FSU Accepted
CALCulate<1|2>:MARKer<1...4>:MAXimum[:P
EAK]
FSE/FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:MAXimum:N
EXT
FSE/FSP/FSU Yes
CALCulate<1|2>:MARKer<1...4>:MAXimum:L
EFT
FSE/FSP/FSU Yes
Table 3-1 SCPI Commands Summary Table
SCPI Command Corresponding
Model
Support Notes
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html