Agilent Technologies EXA N9010A - Page 42

41
Compatible SCPI Commands
SCPI Summary Table
CALCulate<1|2>:LIMit<1...8>:CONTrol:DOMai
n FREQuency | TIME
FSE/FSP/FSU Yes
CALCulate<1|2>:LIMit<1...8>:CONTrol:OFFSet
<numeric_value>
FSE/FSP/FSU Yes
CALCulate<1|2>:LIMit<1...8>:CONTrol:MODE
RELative | ABSolute
FSE/FSP/FSU Yes
CALCulate<1|2>:LIMit<1...8>:CONTrol:SHIFt
<numeric_value>
FSE/FSP/FSU Yes
CALCulate<1|2>:LIMit<1...8>:CONTrol:SPACin
g LINear | LOGarithmic
FSE/FSP/FSU Yes
CALCulate<1|2>:LIMit<1...8>:LOWer[:DATA]
<numeric_value>,<numeric_value>...
FSE/FSP/FSU Yes The unit supported are
DBM and DB.
CALCulate<1|2>:LIMit<1...8>:LOWer:STATe
ON | OFF
FSE/FSP/FSU Yes
CALCulate<1|2>:LIMit<1...8>:LOWer:OFFSet
<numeric_value>
FSE/FSP/FSU Yes The unit supported are
DBM and DB.
CALCulate<1|2>:LIMit<1...8>:LOWer:MARGin
<numeric_value>
FSE/FSP/FSU Yes The unit supported are
DBM and DB.
CALCulate<1|2>:LIMit<1...8>:LOWer:MODE
RELative | ABSolute
FSE/FSP/FSU Yes
CALCulate<1|2>:LIMit<1...8>:LOWer:SHIFt
<numeric_value>
FSE/FSP/FSU Yes The unit supported are
DBM and DB.
CALCulate<1|2>:LIMit<1...8>:LOWer:SPACing
LINear | LOGarithmic
FSE/FSP/FSU Yes
CALCulate<1|2>:LIMit<1...8>:LOWer:THResho
ld <numeric_value>
FSP/FSU Yes The only unit supported is
DBM.
CALCulate<1|2>:LIMit<1...8>:UPPer[:DATA]
<numeric_value>,<numeric_value>...
FSE/FSP/FSU Yes The unit supported are
DBM and DB.
CALCulate<1|2>:LIMit<1...8>:UPPer:STATe ON
| OFF
FSE/FSP/FSU Yes
CALCulate<1|2>:LIMit<1...8>:UPPer:OFFSet
<numeric_value>
FSE/FSP/FSU Yes The unit supported are
DBM and DB.
CALCulate<1|2>:LIMit<1...8>:UPPer:MARGin
<numeric_value>
FSE/FSP/FSU Yes The unit supported are
DBM and DB.
CALCulate<1|2>:LIMit<1...8>:UPPer:MODE
RELative | ABSolute
FSE/FSP/FSU Yes
Table 3-1 SCPI Commands Summary Table
SCPI Command Corresponding
Model
Support Notes
This Manual:http://www.manuallib.com/agilent/n9062a-signal-analyzer-user-guide.html