Appear TV DC100X - ISDB-T Input

APPEAR AS Confidential 104/352
Sync
MPEG sync number: 188 or 204
Effective Bitrate
Effective bitrate of the input stream
Total Bitrate
Total bitrate of the input stream
Lock Status
Lock status of the tuner
Level
RF level measured in dBmV
MER
Modulation Error Radio in dB - a typical good reading is between 30 and 40 (the
higher the better).
5.4.8 ISDB-T INPUT
The ISDB-T input module can receive up to four individual Frequencies. To configure the module:
• Switch to the Inputs node in the Navigation Pane
• Select the ISDB-T module you want to configure and the module configuration window will be displayed.
Services available on all four ISDB-T input frequencies will be listed in this view.
The ISDB-T input window shows all configurable settings as well as the current bitrate and service information.
The following parameters are available:
Enable
Enable the corresponding input port
Input
Port on the ASI input module
Services
Number of services available on this port
Mode
Analysis mode of input port
Freq[MHz]
Specify the currently tuned frequency in MHz, valid range is 47 – 861MHz.
Bandwidth
Input signal bandwidth (6 – 8 MHZ)
Rate [Mbit/s]
Incoming data rate
CC Err
Continuity Counter Error – indicates that one or more packets are lost
The above list of parameters can be configured by clicking on the pencil icon to the right of each input.