APPEAR AS Confidential 271/352
The following parameters are available for Service setup section:
Enable/Disable Automatic Mode
This parameter controls the UDP port offset of the transport stream containing
the output service.
Displays the Video Format
Specifies the Audio Format peer output
Enables MS output Services. When selected, this video/audio will have an SPTS
created automatically on the output
When enabled, this allows the specific video/audio to be selected and routed to
an output module as a standard output service.
9.8.2 OUTPUT SCHEME
Coding a service with a particular coding profile will generate multiple video and audio components, carrying the
same content, but in different formats. The configuration system will automatically generate the necessary
output MPEG TS to be able to transport all the generated components. Currently only SPTSs will be supported,
where the system generates one SPTS per video component.
The settings for these generated transport streams are defined in re-usable output profiles (currently names
output schemes).
To Next Page
Loading...