APPEAR AS Confidential 157/352
Video Modulation depth. This level can be adjusted from 80 to 90%. This parameter is
only available for the HP RF Decoders.
Determines how video is clipped before modulation. Enabling clipping result in video
being clipped 5% above configured modulation depth. Off means video is not clipped.
This parameter is only available for the HP RF Decoders.
Continuous Wave Mode. The output will be an un-modulated video carrier with no
audio carriers present.
Enables the RF signal on the output. The RF output signal will be turned off when this
is not enabled.
Every time the system boots or a change has been applied to the RF Frequency, RF Power Level, or RF Enable,
the decoder will automatically calibrate the power level to match the selected power output level.
7.2.8.1 Semi-agile frequency setting
When configuring the Quad Decoder module with 8 output channels, it is possible to configure the channel spacing
for the x2 output frequencies. This allows the operator to have no, one or two channel spacing between the output
carriers, depending on the channel width.
The available options are under User defined RF channel list are;
ITU (Low Band)
• 7 MHz
• 14 MHz
• 21 MHz
ITU (High band) and OIRT
• 8 MHz
• 16 MHz
• 24 MHz
Manual
• 7 MHz
• 7.0625 MHz
• 8 MHz
• Manual
Manually enter the channel spacing in the text box.
To Next Page
Loading...