APPEAR AS Confidential 297/352
Specify an XMLTV tag name for schedule information. This relies on EPG XMLTV
import which is covered in the Appear EPG XMLTV Interface document.
By default, if no tag is specified, this will be <NetID>.<TSID>.<ServiceID> corresponding
to the output service,The EPG schedule will not be taken from an EIT table from an
input source but from an external XMLTV file that will be transferred to the EPG
module. Please refer to the “Appear EPG XMLTV Interface” document for more details.
Manually specify an incoming source (Slot, Port, NetworkID, TSID, ServiceID) of EIT
information
If more than one input source match the outgoing service, according to the Matching
Criteria configured in the EPG Setup node, it will list all of them.
Other settings must be configured:
Specify an XMLTV tag name for schedule information. This relies on EPG XMLTV
import which is covered in the “Appear EPG XMLTV Interface” document.
By default, if no tag is specified, this will be <NetID>-<TSID>-<ServiceID>
corresponding to the output service.
Apply a time offset to the EPG schedule if required, choose “None” otherwise.
Enable if EPG module should re-generate outgoing EIT table for Present (Current
program) and Following (Next program)
Enable if EPG module should re-generate outgoing EIT table for full schedule
Extended Event
Descriptor
Enable if these elements in the EIT table are causing some EPG display or presentation
issue in the set-top-box, to remove them from the EIT table. Disabled by default.
The EIT extended event descriptor contains a list of items. This list is used to hold set-top box configuration.
In order to configure the user can launch EPG Source page and can edit for each service.
There are two new checkboxes were implemented:
1.) Empty Item List.
2.) Empty Text.
The default option is to do nothing.
To Next Page
Loading...