APPEAR AS Confidential 5/352
8.2 AUTO SERVICE MODES 170
8.2.1 Configuring an output with Auto All Services 171
8.2.2 Configuring an output with SID conflict mode 172
8.3 TRANSPORT STREAM GENERATION 172
8.3.1 Transport Settings 175
8.3.2 Port Settings 177
8.3.3 EMM 178
8.3.4 HbbTV Apps 179
8.3.5 PSI 180
8.3.6 EPG 181
8.3.7 Service 181
8.3.8 Components 184
8.3.9 Scrambling 188
8.4 OUTPUT PORT SETTINGS 190
8.4.1 IP Output module 190
8.4.2 Cloned IP Output Module 192
8.4.3 Dual IP Output 194
8.4.4 ASI Output Module 195
8.4.5 QAM Output Module 196
8.4.6 COFDM Output Module 198
8.4.7 DVB-S/S2, DVB-S2X Output Modules 199
8.4.8 DVB-T2 Output Module 202
8.4.9 ISDB-T Output Module 203
8.4.10 SRT IP Output Module 204
8.5 OUTPUT OPTIONS 205
8.5.1 Enable/Disable Services in Outgoing MPTS. 205
8.5.2 Virtual MPTS Output 206
8.5.3 MPTS Transparent Mode 207
8.5.4 MPTS Semi-Transparent Mode 207
8.5.5 Service Filtering in Semi-Transparent Mode 208
8.5.6 Service Priority Selection 209
8.5.7 Popup warning if new service exceeds available MPTS bitrate 210
8.6 PSI/PSIP CONFIGURATION 210
8.6.1 Editing the PSI Network configuration 212
8.6.2 NIT Mapping in PSI Network configuration 213
8.6.3 Editing the PSI Default Values 214
8.6.4 Editing the Logical Chanel Descriptor (NIT) 216
8.6.5 Editing the BAT table 217
8.6.6 Editing the TOT Local Time Offset Descriptor 218
8.6.7 PSI Synchronization 219
8.6.8 Inserting Generic Descriptors 221
8.6.9 Inserting DVP STP 222
8.6.10 PSI Generation Setup 223
8.6.11 DVB → ATSC, ATSC → DVB Conversion 225
8.6.12 SI Domain Support 226
8.7 PMT SWITCHING CONFIGURATION 226
9 ENCODER AND TRANSCODER CONFIGURATION 228
9.1 GENERAL INFORMATION 228
9.2 ENCODER MODULES 229
9.2.1 Hardware Configuration (EC-400) 231
To Next Page
Loading...