APPEAR AS Confidential 8/352
12.7.4 EMMG Redundancy 331
13 CONTROL AND MONITORING 332
13.1 SYSTEM STATUS 332
13.1.1 Service View 332
13.1.2 Output View 333
13.1.3 Hardware View 335
13.1.4 Active Alarms 335
13.1.5 Alarm History 336
13.1.6 Alarm Setup 337
13.1.7 Root Cause Filter 338
13.1.8 Monitoring 338
13.2 SNMP 342
13.2.1 Configuration of SNMP Community Strings in GUI 342
13.2.2 Configuration of SNMP Heartbeat rate in GUI 342
13.2.3 Configuration of SNMP Alarm Filter via the GUI 342
13.2.4 Configuration of SNMP Trap Destination Table via the GUI 343
13.2.5 Configuration of Trap Destination Table via SNMP 343
13.2.6 Interpretation of Traps 343
13.3 SOAP XML INTERFACE 344
14 MAINTENANCE 345
14.1 SOFTWARE UPGRADES 345
14.2 HOT-SWAPPING 345
14.2.1 Performing a Hot-Swap 345
14.2.2 Switch+MMI Module Hot-swap 345
14.2.3 Other Module Hot-swap 346
14.3 ADDING, REPLACING, OR REMOVING MODULES 346
14.4 IMPORTING AND EXPORTING CHASSIS CONFIGURATION 347
14.5 MAINTENANCE CENTER ACCESS 347
14.6 SUPPORT FOR CONFIGURATION BACKUP 348
14.7 SYSLOG EXPORT OF ALARMS 349
14.8 EXPORT OF ALARM HISTORY 349
14.9 RESTORING THE DEFAULT IP ADDRESS 350
14.10 RESTORING THE DEFAULT IP ADDRESS FOR 1RU (XC5100). 350
14.10.1 Resetting IP address using USB Cable 350
14.10.2 Resetting IP address with DIP switch 351
14.11 RESTORING THE DEFAULT CLI PASSWORD 351
A NOTICES 352
To Next Page
Loading...