Belarus 892 - Page 259

892-0000010B OM
259
6.4.5 Maintenance service in every 1000 hours of operation
6.4.5.1 General guidelines
Complete the abovementioned operations, and the operations, listed in the present
subclause 6.4.5 also.
6.4.5.2 Operation 45. Check of axial play and adjustment of taper bearings of wheel flange
With the help of an indicator, check the axial play in taper bearings 9, 10 (Figure
6.4.35) by measuring the shift of flange 11.
Taper bearings shall have no axial play. If it is detected, adjust the bearings as fol-
lows:
- unscrew the bolts and remove the cover that closes nut 8 (Figure 6.4.35);
- tighten the nut with the torque from 180 to 200 Nꞏm, then deflect to the angle of 15
to 20
0
. When tightening the nut, it is necessary to turn through flange 11, so that the bear-
ing’s rollers take the correct position in the cages;
- after the adjustment, punch the nut collar into the two slots of flange. Angular shift if
the nut is not allowed.
6.4.5.3 Operation 46. Oil change in combined tank of HLL and HSC (in HLL tank)
Note – The operation shall be performed for tractors with universal cabin (with canopy
frame or canopy base on the basis of universal cabin)
Before oil change, heat up the oil in the hydraulic system of HLL and HSC (HLL) to
reach the normal operating temperature by starting the engine and setting any of the levers
of hydraulic outlet control to the “Uplift” position and keeping the lever in such position until
the hydraulic system is heated.
To change oil in hydraulic systems of RLL and HSC, do the following:
- put the tractor on a flat ground, raise the RLL links to their top position, brake the tractor
using the parking brake. The engine shall be stopped;
- unscrew the plug of oil filler opening 2 (Figure 6.4.37) and drain plug 3; drain the oil from
the oil tank into a special container for used oil;
- re-place drain plug 3 and fill the system with fresh oil up to the mark “П” on oil level indicator 1.
When using machines that require large oil extraction, fill oil to the level of upper mark “С”.
- re-place the plug of oil filler opening 2.
1 – oil level indicator; 2 – plug of oil filler opening; 3 – drain plug.
Figure 6.4.37 – Oil change in hydraulic systems of RLL and HSC
ATTENTION: THE OPERATION OF OIL CHANGE IN HLL AND HSC SHALL BE
PERFORMED ONLY WITH RETRACTED RODS OF RLL HYDRAULIC CYLINDERS AND
OF MACHINES COUPLED WITH THE TRACTOR!
WARNING: BE CAREFUL TO AVOID CONTACT WITH HOT OIL!