892-0000010B OM
270
16. Check and, if necessary, tighten three M16 bolts attaching the housing of the
propshaft intermediate support to the clutch body with a torque of 100 to 120 Nm.
17. Check and, if necessary, tighten the nuts for the taper attachment of the steering cylinder
pins, to do this proceed as follows:
- unlock the crown nuts;
- check and, if necessary, tighten the crown nuts of the steering cylinder pins with a torque
of 180 to 200 Nm (for "Belarus-892" - two M24 nuts for "Belarus-892.2" - two M27 nuts);
- then tighten the nut to match the nearest slot on the nut with a hole in the pin and forelock.
18. Check and, if necessary, tighten the points attaching the bracket of the HSC cylinder to
the FDA housing (for BELARUS-892 - two M16 bolts with a torque of 180 to 200 Nm, for BELA-
RUS -892.2 - three M16 nuts with a torque of 110 to 140).
To Next Page
Loading...
