892-0000010B OM
48
Diagram of arrangement and connection of the outputs of the distributor RS-213 BEL-
ARUS to the external loads on the BELARUS-892/892.2 tractor is shown in Figure 2.15.6.
Figure 2.15.6 – Diagram of arrangement and connection of the outputs of the distrib-
utor RS-213 BELARUS to the external loads.
2.15.3.4 Control of remote hydraulic cylinders with distributor RP70-1221TS installed
by means of joystick and lever
When the distributor RP70-1221TS is installed on tractors, remote control of the dis-
tributor spools is possible, which is carried out by joystick 1 (Figure 2.15.7) and lever 2 using
double-acting cables. The joystick and lever are installed on the right control panel in the
tractor cab instead of the handles for controlling the outputs of the HLL distributor.
Joystick 1 is meant to control two spools (sections) of the distributor:
- as you move the handle of joystick 1 in the longitudinal direction, you control the
spool, related to the left side outputs of the hydraulic system.
- as you move the joystick handle in the transverse direction, you control the spool
related to the right side outputs.
Lever 2 moves only in the longitudinal direction and controls the middle spool related
to the rear left outlets of the hydraulic system.
To Next Page
Loading...
