Belarus 892 - Page 47

892-0000010B OM
47
“Uplift” – lowermost non-fixed position. In the “Uplift” position with the engine running,
the handle shall be held by hand, because after released it will return automatically to the
“Neutral” position.
ATTENTION. ON THE BELARUS-892/892.2 TRACTORS, THE DISTRIBUTOR
RP70-1221.1S IS INSTALLED WITH A FIXATION OF THE RIGHT SIDE OUTPUT CON-
TROL SPOOL IN THE "UPLIFT" POSITION (CONTROLLED BY HANDLE 2 (FIGURE
2.15.4)) WITHOUT AUTO RETURN TO THE "NEUTRAL" POSITION. THEREFORE,
WHEN WORKING USING THE SPECIFIED SPOOL IN THE “UPLIFT” POSITION, DO NOT
FORGET TO SET THE CONTROL LEVER FOR THIS SPOOL IN THE “NEUTRAL POSI-
TION” AFTER PERFORMING THE OPERATION IN ORDER TO AVOID OVERHEATING
OF THE HYDRAULIC SYSTEM AND THE PREMATURE FAILURE OF THE PUMP AND
OTHER UNITS OF THE HYDRAULIC SYSTEM!
On request, the RP70-1221S distributor without fixation of the spools in the “uplift”
position can be installed on tractors.
Diagram of arrangement and connection of the outputs of the distributor RP70-
1221.1S to the external loads on the BELARUS-892/892.2 tractor is shown in Figure 2.15.3.
2.15.3.3 Control of remote hydraulic cylinders with distributor RS-213 BELARUS in-
stalled
1, 2, 3 - handle to control outputs of the HLL distributor (remote cylinders); 4 - instruction
shield containing control diagram of the RS-213 BELARUS distributor.
Figure 2.15.5 – Control of remote hydraulic cylinders with distributor RS-213 BELARUS
installed
Each of the three handles 1, 2, 3 (Figure 2.15.5) of the RS-213 BELARUS distributor
has four positions:
"Floating" – uppermost fixed position;
“Forced lowering” – middle upper non-fixed position between “Floating” and “Neu-
tral” positions. In “Forced lowering” position with the engine running, the handle shall be held
by hand, because after released it will return automatically to the “Neutral” position;
“Neutral” – bottom fixed middle position;
“Uplift” – lowermost non-fixed position. In the “Uplift” position with the engine run-
ning, the handle shall be held by hand, because after released it will return automatically to
the “Neutral” position.