737 Flight Crew Operations Manual
Normal Procedures -
Amplified Procedures
Boeing Proprietary. Copyright © Boeing. May be subject to export restrictions under EAR. See title page for details.
D6-27370-866-EGP NP.21.31
Move the control wheel and the control column to full travel in both
directions and verify:
• freedom of movement
• that the controls return to center
• correct flight control movement if the flight control surface
position indications are displayed on the lower display unit.
Hold the nose wheel steering wheel during the rudder check to
prevent nose wheel movement.
Move the rudder pedals to full travel in both directions and verify:
• freedom of movement
• that the rudder pedals return to center
• correct flight control movement if the flight control surface
position indications are displayed on the lower display unit.
Blank the lower display unit. F/O
Transponder mode selector ......................................XPNDR F/O
Recall ..........................................................................Check C, F/O
Verify that all system annunciator panel lights illuminate
and then extinguish.
YK981 - YQ456
CAUTION: Do not use the Airport Map application as a primary
navigation reference. The Airport Map application is
designed to aid flight crew positional awareness only.
EFB AIRPORT MAP application ............................... Select C, F/O
Select map as desired.
Update changes to the taxi briefing, as needed. C or PF
Call “BEFORE TAXI CHECKLIST.” C
Do the BEFORE TAXI checklist. F/O
Before Takeoff Procedure
Engine warm up requirement:
• verify an increase in engine oil temperature before takeoff.
Engine warm up recommendations:
• run the engines for at least 2 minutes
• use a thrust setting normally used for taxi operations.
September 15, 2016
To Next Page
Loading...
