737 Flight Crew Operations Manual
Normal Procedures -
Amplified Procedures
Boeing Proprietary. Copyright © Boeing. May be subject to export restrictions under EAR. See title page for details.
D6-27370-866-EGP NP.21.33
Takeoff Procedure
YW273, YW274
Pilot Flying Pilot Monitoring
Before entering the departure runway, verify that the runway and runway entry
point are correct.
When entering the departure runway,
set the STROBE light switch to ON.
Use other lights as needed.
Set the transponder mode selector to
TA/RA.
Verify that the brakes are released.
Align the airplane with the runway.
Verify that the airplane heading agrees with the assigned runway heading.
When cleared for takeoff, set the
FIXED LANDING light switches to
ON.
Advance the thrust levers to
approximately 40% N1.
Allow the engines to stabilize.
Push the TO/GA switch.
Verify that the correct takeoff thrust is set.
Monitor the engine instruments during
the takeoff. Call out any abnormal
indications.
Adjust takeoff thrust before 60 knots as
needed.
During strong headwinds, if the thrust
levers do not advance to the planned
takeoff thrust, manually advance the
thrust levers before 60 knots.
Call "THRUST SET".
After takeoff thrust is set, the captain’s hand must be on the thrust levers until V1.
September 15, 2016
To Next Page
Loading...
