737 Flight Crew Operations Manual
Supplementary Procedures -
Flight Management, Navigation
Boeing Proprietary. Copyright © Boeing. May be subject to export restrictions under EAR. See title page for details.
D6-27370-866-EGP SP.11.5
Correct any ROUTE DISCONTINUITY if entered waypoint was not
in original flight plan.
If abeam waypoints are desired:
ABEAM PTS key ...................................................................Push
EXEC key ...............................................................................Push
Observe the MOD RTE LEGS page changes to ACT.
Intercepting a Leg (Course) to a Waypoint
RTE LEGS page ............................................................................. Select
On page 1/XX, line 1L, enter desired waypoint over presently active
waypoint.
Observe INTC CRS prompt displayed in line 6R.
Enter the desired intercept course in the INTC CRS line. Observe the
desired course is displayed on line 6R. The displayed course on line
1L may vary by several degrees due to magnetic variation.
Correct any ROUTE DISCONTINUITY if the entered waypoint was
not in original flight plan.
EXEC key .........................................................................................Push
Observe MOD RTE LEGS page changes to ACT.
LNAV may disengage after execution of an intercept leg to a
waypoint. If LNAV disengages, turn to a heading to satisfy LNAV
capture criteria, as described in Chapter 11, and then engage LNAV.
Route Modification
(SB Changes YK981 - YQ456)
RTE LEGS or RTE page ................................................................. Select
Line select existing waypoints in the desired sequence.
Key–in any new waypoints in the scratch pad and line select into the
flight plan. Correct any ROUTE DISCONTINUITY.
EXEC key .........................................................................................Push
Observe MOD RTE or MOD RTE LEGS page changes to ACT.
September 24, 2015
To Next Page
Loading...
