737 Flight Crew Operations Manual
Normal Procedures -
Amplified Procedures
Boeing Proprietary. Copyright © Boeing. May be subject to export restrictions under EAR. See title page for details.
NP.21.52 D6-27370-866-EGP
YK981 - YQ456
After Landing Procedure
Start the After Landing Procedure when clear of the active runway.
Engine cooldown recommendations:
• run the engines for at least 3 minutes
• use a thrust setting normally used for taxi operations
• routine cooldown times less than 3 minutes are not recommended.
Shutdown Procedure
Start the Shutdown Procedure after taxi is complete.
Parking brake .................................................................. Set C or F/O
Pilot Flying Pilot Monitoring
CAUTION: Do not use the Airport Map application as a primary navigation
reference. The Airport Map application is designed to aid flight
crew positional awareness only.
Pilot Flying Pilot Monitoring
The captain moves or verifies that the SPEED BRAKE lever is DOWN.
Start the APU, as needed.
YK994 - YW274
Set the PROBE HEAT switches to
AUTO.
YK981 - YK993
Set the PROBE HEAT switches to
OFF.
Set the exterior lights as needed.
Set the ENGINE START switches to
OFF.
Set the weather radar to OFF.
Set the AUTO BRAKE select switch to
OFF.
Set the flap lever to UP.
Set the transponder mode selector to
XPNDR.
September 15, 2016
To Next Page
Loading...
