737 Flight Crew Operations Manual
Normal Procedures -
Amplified Procedures
Boeing Proprietary. Copyright © Boeing. May be subject to export restrictions under EAR. See title page for details.
D6-27370-866-EGP NP.21.39
Climb and Cruise Procedure
Complete the After Takeoff Checklist before starting the Climb and Cruise
Procedure.
Pilot Flying Pilot Monitoring
During climb and cruise, verify the
RNP as needed.
At or above 10,000 feet MSL, set the
LANDING light switches to OFF.
Set the passenger signs as needed.
At transition altitude, set and crosscheck the altimeters to standard.
During climb, set the affected center
tank fuel pump switch to OFF when a
center tank fuel pump LOW
PRESSURE light illuminates.
Set both center tank fuel pump
switches to OFF when a center tank
fuel pump LOW PRESSURE light
illuminates if the center tank is empty.
When established in a level flight
attitude, if the center tank contains
usable fuel and a center tank fuel pump
switch(es) is OFF, set the center tank
fuel pump switch(es) to ON again.
Set the affected center tank fuel pump
switch to OFF when a center tank fuel
pump LOW PRESSURE light
illuminates.
Set both center tank fuel pump
switches to OFF when a center tank
fuel pump LOW PRESSURE light
illuminates if the center tank is empty.
During an ETOPS flight, additional
steps must be done. See the ETOPS
supplementary procedure in SP.1.
Before the top of descent, modify the
active route as needed for the arrival
and approach.
September 15, 2016
To Next Page
Loading...
