Care & Maintenance
185
PN: 905K520652 v2.8
Breakdown
After each use, the simulator should be properly disassembled and stored in a secure place. To
ensure that the simulator remains in good working condition, follow the prescribed CAE breakdown
procedures below.
Step 1: Clean the Simulator and Fluid Systems
Each time the airway is used during simulation, it must be cleaned of lubricant and fluids with a soft
cloth.
Each time the following are used during simulation, they must be cleaned of lubricant and fluids with
a soft cloth:
• Maternal airway
• Birth canals
• Cervices
• Abdomen
• Fetus
If internal fluid systems were used during simulation (vaginal bleeding, IV fluids, epidural,
genitourinary fluids), the fluid must be drained from the simulator and the fluid systems used must
be cleaned.
For more information on cleaning the fluids, refer to the section Cleaning the
Internal Systems.
Breakdown Steps
1 Clean the Simulator and Fluid Systems
2 Shut Down the Software
3 Power Off the Simulator
4 Power Off the Fetus
To Next Page
Loading...
