EasyManua.ls Logo

CAE Athena - Clean the Internal Systems; Cleaning the IV System

CAE Athena
284 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Care & Maintenance
190
CAEAthena
PN: 905K520652 v2.8
Batteries require approximately four hours to fully charge.
Note: Batteries will lose charge over time when left in a stored, unused simulator. When storing the
simulator for an extended amount of time, remove the batteries from the simulator.
Clean the Internal Systems
The internal systems of the manikin must be cleaned after each simulation session. Only the systems
that were used need to be cleaned.
Cleaning the IV System
To clean the IV system:
1. Connect an empty 140 mL syringe to the IV DRAIN port located on the left side of the
simulator’s torso
The Ports
2. Slowly withdraw air from the port until a vacuum is formed. If only clear fluid was
injected into the IV system during use, the cleaning procedure is complete.
IMPORTANT: If colored fluid was injected in the IV system, complete the Priming the IV System instructions
in the Using Athena section with clear fluids and complete the Cleaning the IV system instructions for a
second time.
The IV
DRAIN
port

Table of Contents

Related product manuals