CAE Athena - Step 2: Shut down the Software; Step 2: Power off the Simulator; Maintenance Advice

Care & Maintenance
186
CAEAthena
PN: 905K520652 v2.8
Step 2: Shut Down the Software
To shut down the Müse software:
1. Stop any running SCEs
2. Click the Account Name in the lower, right-hand corner of the screen
The Logout dialog box appears.
3. Click Logout to exit the software
To shut down the TouchPro Patient Monitor software:
1. Click the Settings button in the bottom, right-hand corner of the TouchPro Patient
Monitor screen
2. From the Settings menu, click Shutdown
3. Click Shutdown
Step 2: Power Off the Simulator
Press the power button, on the right-side of the simulator’s torso for two seconds.
It will take a moment to cycle down and the indicator light will turn off when the simulator is
completely shut down.
Maintenance Advice
Simple care and maintenance helps to ensure that the simulator stays in good working condition.
Many problems are caused by inadequate or improper maintenance. Perform a thorough check of
the various components each time the simulator is used.