Chery QQ Service Manual Transmission System
-27-
Section 3 Maintenance on car
Ⅰ.Maintenance
(1) The Clutch Pedal Height
According to the following regulations, use pedal bracket adjusting bolt to adjust the
clutch pedal height. It is normal if the height of clutch pedal is higher 8mm(0.3in)than the
height of brake pedal..
(2) The free play of the clutch pedal.
Step on the clutch pedal till you feel the resistance, stop stepping and mensurate
the distance clutch pedal free play. The free play must be within the following stated
ranges.
If the free play is wrong, please adjust the clutch cable free play according to the
diagram below.
While checking clutch pedal free play, be sure to check if the working state of the
clutch is normal under the circumstance that the engine is running.
(3) Clutch Switch
Attention:
This switch is applicable to the vehicles with catalyst.
Adjust:
1. Pull the parking brake handle, push the shift lever to the neutral positon.
2.Take apart the connect beside the pedal Bracket.
3.Loosen the lock nut.
4. Adjust the installation position of the gearing position of clutch pedal, the clearance
between switch connect and clutch bracket is the size A, then tighten the lock nut.
5. Connect.
N.m
Kg-m
1b-ft
The clutch switch
lock nut adjustment
torque
10-15 1.0-1.5 7.5-10.5
（4）Clutch Cable
Unload:
Dismantle the clutch cable connect nut , and move off connection lock on the
inner cable.
Take apart two bolts from the front wainscot, cable top from the table, at last take out
the cable.
Check:
Check the clutch cable, if appears one of the following status, replace the cable.
Chery Automobile Co., Ltd
To Next Page
Loading...
