CHERY SQR7080 EZ Drive SERVICE MANUAL
CONTROL OF MACHINE PARTS
– AIR FILTER & SERVO BRAKE CHECK VALVE
Change of air filter
When replacing the air filter element, it is
unnecessary to remove the servo brake.
Take out the worn filter element (F) from below the
pedal support by using a screwdriver or metal hook.
Cut the new filter element into the shape “A” (see
the figure), mount it around the pushrod, and sent it
into the chamber slowly. Make sure that it shall
fully stretch in the boring hole to prevent the
unfiltered air from going through.
Replace the check valve
This operation can be carried out in the vehicle.
Disassembly:
Disconnect the servo relief inlet pipe.
Move the rubber seal ring by rotating the check
valve and take it out.
Reassembly:
Check the seal washer and check valve.
Replace any faulty parts.
Place back the assembly.
PDF created with pdfFactory Pro trial version www.pdffactory.com
To Next Page
Loading...
