Chery QQ - Removal and Installation of Rear Foglight; Removal and Installation of Interior Ceiling Light

Chery QQ Service Manual
——Insert base line of the lamp into sheet-metal hole, screw hole on the lamp and
oncentric, then tighten tapping screw.
installation of rear foglight
Removal:
the b e vehicle if possible.
e
e
hould distinguish left and right(“L” mark in the left lamp, “R” mark in
the r put the foglight into the install hole, insert two pins into location
. Removal and installation of interior ceiling light
Removal:
shell, prize the shade carefully;
screw hole on the sheet-metal is c
——insert two bolts of license plate into sheet-metal hole, install the nut and tapping
screw, adjust install position then tighten nut and tapping screw;
——Assemble the luggage compartment lid trim board, close the luggage
compartment lid.
7. Removal and
——Raise the vehicle and then remove from
ottom of th
——Loose two nuts then take out the foglight
——Remove the harness connector, then tak
down the foglight from the location hole of th
front bumper
Installation:
——First you s
ight lamp ), then
notch, then tighten it by bolt with nut;
——Connect the foglight harness connector;
8
——Insert flat-tip screwdriver between shade and
——Remove two tapping screw of front ceiling
light by screwdriver.
——Disconnect lamp holder harness.
- 47 -