Chery QQ - Removal and Installation of Front Foglight

Chery QQ Service Manual
Installation:
light in corresponding position, ensure the bolt fixing hole and the
torque 1.6～2.0 N·m. Drop the
3. Removal and installation of front foglight
ou can raise the car first then remove
.
arness connect plug, take out the front
front bumper
stallation:
—First ensure left and right (left lamp sign“L”,
“R”), then put the foglight into
a. Install head
headlight cross member welding nut are concentric;
b. Locate the headlight by three M6 bolts with the
engine compartment hood, verify and adjust the assembly position of headlight,
headlight should protrude from engine compartment hood a little, you can feel that
there is a radian between them by your hands, then tighten the fastener.
Removal:
If possible, y
form bottom
——Loose the nut, take out the bolt
——Remove h
foglight from the location hole of the
In
—
right lamp sign
installation hole from front, insert two locating pin
into location notch and use bolt and nut to tighten it.
——Connect foglight harness butt joint;
- 44 -