CHERY SQR7080 EZ Drive SERVICE MANUAL
BRIEF INTRODUCTION TO MECHANICAL TRANSMISSION
Automated mechanical transmission is a manual mechanical transmission equipped with an electronically
controlled hydraulic unit, in which an embedded computer controls both operating of the clutch and
changing of the drive ratio. Thus, there is no need to provide a clutch pedal and speed control is
implemented through an electronic contact lever, and the accelerator and brake pedals are electronically
connected to the engine through the embedded engine computer. This not only reduces the gear shifting
time but also ensures more comfortable feeling delivered to the driver and passengers.
Dialogue: (you shall do the following things every time you come to a workshop)
Check:
– Hydraulic oil level (refer to the section of “OIL TANK”)
– Horn performance
l Pull up the hand brake
l Start the vehicle
l Provide the vehicle with a speed (the letter “A” will be shown on the instrument
board)
l Open the driver-side door
The horn should be in good condition.
– Whether safety performance can prevent the vehicle from starting.
l Pull up the hand brake
l Provide the vehicle with a speed (do not step down the brake pedal)
l Try to start the vehicle
The starter should be incapable of working.
Towing:
If the transmission gets stuck at some gear position:
– Ignite the engine
– Step down the brake pedal
– Select the neutral position
– Check that the transmission is really in the neutral position (as you can push the vehicle)
If it is impossible to change the transmission to the neutral position, you shall suspend the front wheels
and tow the vehicle.
The engine must be turned off when you tow the vehicle.
PDF created with pdfFactory Pro trial version www.pdffactory.com
To Next Page
Loading...
