Chery QQ - Removal and Installation of Front Turn Signal Lamp

Chery QQ Service Manual
4. Removal and installation of front turn signal lamp
emoval:
f possible.
—— screws the take out the turn signal lamp
e
—First you should distinguish left and right(“L” mark in the left lamp, “R” mark in
th then put the turn signal lamp into the install hole, at last tighten two
tion tail lamp（include
）
two tapping screw, then pull out the lamp;
——Connect the lamp seat harness;
R
——Raise the vehicle and then remove from the bottom of the vehicle i
Loose two
——Remove the harness connector, then take down the turn signal lamp from th
location hole of the front bumper
Installation:
—
e right lamp ),
tapping screw on the install hole;
——Connect the turn signal lamp harness connector;
5. Removal and installation of combina
parking light/braking light, turn signal lamp, backup light
Removal:
——Open the luggage compartment lid;
——Loose
——Pull down the lamp seat harness.
Installation:
- 45 -