Chery QQ Service Manual Chassis System
Rinse power steering system
103
Attention: Use suitable steering fluid when
filling or replacing fluid, otherwise it will
damage hose and seal.
1. Lift vehicle to run wheel freely.
2. Suck out fluid from tank.
3. Remove fluid hose from connector.
4. Insert outlet of hose into tank.
5. Put hose into container.
6. Run engine at idle. Ask assistant to fill
fluid into tank.
7. Turn steering wheel left and right.
Attention: Don’t turn to end for starring
wheel to keep on. Otherwise it will cause
over heat for system or damage pump and
pivot.
8. Continues to drain out all old fluid.
9. Resin system with 0.9L new fluid.
10. Check if all fluid is drained out.
11. Remove the cock of pump.
Points of attention:
Don’t use the fluid drained out.
12. Connect hose and tank.
13. Turn off engine.
14. Fill fluid into tank.
15. Check if any leak in tank.
16. Drain out air of system.
Power steering box replace
Disassembly procedure
1. Remove 3 bolts first.
2. Loosen nuts on hose. Note to collect fluid.
3. Remove bolts on left/right transverse lever.
Chery Automobile Co., Ltd
To Next Page
Loading...
