Chery QQ - Operation Process

Chery QQ Service Manual BCM Computer Control System
antitheft indicator will flash once. This indicates this remote control has entered into
the system.
Note: The first remote control is set into the system After Step 3). Following that, press
any key of the second remote control to set it into the system. Many service stations only
operate one remote control hereto. So, another control doesn’t work after setting.
Furthermore, the settings will definitely fail in case of improper process or operation. In
this case, do not replace remote control or module casually. Be advised to try again
strictly according to this operation process. Operate as in the figure below.
Operation process:
Insert key into the
hole
Turn ignition
switch on
Indicator flashes 3
seconds
Indicator
extin
g
uishes
Indicator
li
g
hts u
p
a
g
ain
Wait until indicator
extinguishes
Turn ignition
switch on
Press lock key of anothe
r
remote control
Turn ignition switch off, wait until
10 seconds for match success
Turn ignition
switch on
Turn ignition
switch off
Turn ignition
switch off
Turn ignition
switch on
Within 7 seconds
Press lock key o
f
remote control
Turn ignition
switch off
- 90 -