Chery QQ Service Manual Charging System
Fault indicator comes on
Symptom Possible Reasons Measures
While the ignition switch is
switched on and the engine is
stopped, the charging indicator
light doesn't light up.
●The fuse snaps.
●Something wrong with indicator
lamp in the cluster gauge.
●The connection gets loose.
●Something wrong with the
regulator of integrated circuit.
Check the fuse.
Check the cluster
gauge.
Tighten what is loose.
Replace regulator of
integrated circuit.
When the engine runs, the charging
indicator light doesn’t go out, and
the battery needs frequent
recharging.
●The driving belt is loose or worn
out.
●The battery cable gets loose, rusty
or worn out.
●Regulator of integrated circuit or
generator doesn’t work well.
●Bad connection
Adjust or replace the
driving belt.
Repair or replace
driving belt.
Repair or replace
cable.
Check charging
system.
Repair the connection.
Unchargable Battery
The slow starting may result from one or some of the following factors, even though
the indicator light works normally. Operate according to the following steps using
voltmeter and ampere meter.
1. Ensure that being uncharged is not due to keeping the accessory equipment
working.
2. Check the driving belt for degree of tightness.
3. If you doubt whether the battery works well, please see section “battery” for further
details.
4. Check the connection for fault. Check whether all the connections are firm and
clean, and check the cranking motor and ignition grounding cable.
5. Connect the voltmeter and ampere meter according to the following chart.
- 22 -