Chery QQ - Page 241

Chery QQ Service Manual Chassis System
6)Brake caliper bracket replace
Disassembly procedure
Points of attention: Don’t
disconnect hose from caliper. Don’t
suspend caliper on hose.
1、Remove caliper. See“ Remove
caliper”.
Warning: Replace all fixture parts if
they are loose or removed, otherwise it
will cause personal hurt or vehicle
damage.
Points of attention: New caliper bolts
have been smeared bolt seal glue.
2、Remove caliper support bolts.
3、Remove caliper support bolts.
4、Remove hood bolts and bush from
support.
5、Check if support is broken.
6、Replace new support if necessary.
Steps of installation
1、Use lubricant to lubricate parts.
2、Install following parts on support.
 Bolt protector
 Bush
3、Screw bolts to fix caliper support.
Fixture
Screw torque: 165N.m.
4、Install caliper. See “Replace brake
caliper”.
7) Brake disc replace
Disassembly procedure
1. Support and lift vehicle.
2. Remove tire and wheel.
3. Check the thickness of brake disc.
4. Remove brake caliper.
5. Remove caliper support.
6. Remove brake disc bolts and brake
disc.
7. Clear interface between the disc and
the wheel hub flange.
Steps of installation
1. Install brake disc
2、Install the disc bolts.
Fixture
Screw bolts to 6 N.m.
3、Install caliper.
4、Install caliper support.
5、Install tire and wheel
6. Lower vehicle
31
Chery Automobile Co., Ltd