engine oil drainer
Torque: 6±1N.m
6.4 Assembly of the oil pan
6.4.1 Clean up the joint surface between the oil pan with
the cylinder.
6.4.2 Spread sealant, then assemble it.
Grease: Loctite 5699
Notice: ·The sealing line should be unbroken with its
diameter being ф3-4mm
·Assembly should take place fifteen minutes
after glue-spreading.
6.4.3 Tighten the bolts in the middle first up to the
specified torque, then the bolts beside them as shown in
the right figure.
Torque: 6±1N.m
Front
Rear
To Next Page
Loading...
