Cisco 10000 Series User Manual

5-17
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 5 Distributing Bandwidth Between Queues
Distribution of Remaining Bandwidth Using Ratio
Step 9
shape {average | peak} cir [bc] [be]
(Optional) Shapes the average or peak rate to the rate you
specify.
average specifies average rate shaping.
peak specifies peak rate shaping.
cir specifies the committed information rate (CIR), in bits
per second (bps).
(Optional) bc specifies the committed burst size, in bits.
(Optional) be specifies the excess burst size, in bits.
Step 10
service-policy child-policy-name
Applies the child policy map you specify to the traffic class.
The router applies the QoS actions specified in the child
policy to the traffic class.
child-policy-name is the name of the child policy.
Note The service-policy command typically requires that
you specify the direction of the traffic using the
input or output keywords. However, when
applying a child policy to a parent policy, do not
specify traffic direction.
Step 11
exit
Exits policy-map class configuration mode.
Step 12
exit
Exits policy-map configuration mode.
Step 13
interface type slot/module/port.subinterface
[point-to-point | multipoint]
Creates or modifies the interface you specify. Enters
subinterface configuration mode.
type is the interface type (for example, Gigabit Ethernet).
slot/module/port.subinterface is the number of the
subinterface that identifies the subinterface (for example,
1/0/0.1).
(Optional) point-to-point indicates that the subinterface is
a point-to-point subinterface.
(Optional) multipoint indicates that the subinterface is a
point-to-multipoint subinterface.
Command or Action Purpose

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English