Cisco 10000 Series User Manual

14-10
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 14 Simultaneous Policy Maps
Configuring Simultaneous Policy Maps
Configuration Example of Attaching a Policy to an ATM VC with PPPoA Sessions
The following example shows how to attach a simultaneous policy map named pppoa_output_policy to
PVCs in the range of 42/101 to 42/110 on the multipoint ATM interface 3/0/0.42101:
interface ATM3/0/0.42101 multipoint
range pvc 42/101 42/110
vbr-nrt 2000 2000 1
Command Purpose
Step 1
Router(config)# interface atm number
[point-to-point | multipoint]
Creates or modifies a subinterface. Enters subinterface
configuration mode.
number is the slot, module, port, subinterface number of the
interface (for example, 4/0/1.10).
point-to-point indicates that the subinterface connects directly
to one endpoint.
multipoint indicates that the subinterface connects to multiple
endpoints.
Step 2
Router(config-subif)# range pvc
start-vpi/end-vpi start-vci/end-vci
Defines a range of ATM permanent virtual circuits (PVCs).
(Optional) start-vpi/ is the beginning value for a range of virtual
path identifiers (VPIs). In the absence of the "/" and a VPI value,
the VPI value defaults to 0. Valid values are from 0 to 255.
(Optional) end-vpi is the end value for a range of virtual path
identifiers (VPIs). In the absence of an end-VPI value, the
end-VPI value defaults to the start-VPI value. Valid values are
from 0 to 255.
start-vci/ is the beginning value for a range of virtual channel
identifiers (VCIs). Valid values are from 32 to 65535. You must
specify the slash mark (/).
end-vci is the end value for a range of virtual channel identifiers
(VCIs). Valid values are from 32 to 65535.
Step 3
Router(config-subif-atm-vc)# vbr-nrt
output-pcr output-scr output-mbs
Configures the variable bit rate-nonreal time (VBR-NRT)
quality of service (QoS).
output-pcr is the output peak cell rate (PCR), in kbps.
output-scr is the output sustained cell rate (SCR), in kbps.
output-mbs is the output maximum burst cell size, expressed in
number of cells.
Step 4
Router(config-subif-atm-vc)# encapsulation
aal5mux ppp virtual-template number
Configures the ATM adaptation layer (AAL) and encapsulation
type for the PVC range.
ppp configures the interface for PPP routing.
number is a number that identifies the virtual template.
Step 5
Router(config-atm-vc)# service-policy
output policy-map-name
Attaches the specified policy map to the specified PVC range in
the outbound direction.
policy-map-name is the name of a previously configured policy
map.

Cisco 10000 Series Specifications

General

Brand	Cisco
Model	10000 Series
Category	Network Router
Language	English