Cisco 10000 Series - Page 852

Index
IN-22
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
description of 2, 15
design guidelines for marking 21
discard-class 16, 33
internal 2
IP precedence 22
Layer 2 marking 2
Layer 2 to Layer 3 mapping 3
Layer 3 marking 2
MPLS experimental 31
QoS group 28
recommended values for marking 21
restrictions for marking 20
set ip dscp and set ip precedence commands for a
packet
10
verifying marking 37
weighted random early detection marking 3
MPLS experimental marking 14
policing 11, 26
QoS group marking 13
shaping, Frame Relay 6
traffic bumping 3
traffic engineering
activating
interfaces 23
routers 21
configuration examples
midpoint routers 30
tail-end routers 31
tunnel head routers 28
verifying configurations 26
traffic marking
class of service 11
configuring differentiated services code point 24
interfaces not supporting marking 20
interfaces supporting marking 20
IP precedence values 4
MPLS marking 15
multiple priority levels 3
QoS group 13
traffic shaping
atm pxf queuing and shaping 8
bandwidth 10
class-based 3, 14
comparing
shaping and policing 11
shaping mechanisms 10
Frame Relay 8, 5, 6
hierarchical shaping 4, 15
interfaces not supporting shaping 13
interfaces supporting shaping 13
overview 2
shaping classes 14
VC level 15
verifying traffic shaping 17
transmit policing action 4
tunneling mode
MPLS QoS 3
pipe 3, 10
short pipe 3, 9
uniform 3
tunnel interfaces, configuring attributes 24
tunnel packets, applying QoS policies 32
tunnels
global pool 20
sub-pool 19
type of service field
description of 4
DSCP bits 6
U
ubr+ command 8, 9
UBR, See unspecified bit rate.
ubr command 15, 8
uniform tunneling mode 3
unshaped UBR 13
unspecified bit rate 14, 15, 8, 9
user-defined offset