Cisco 9971 - Set Device Authentication Field

Table 21: 802.1X Authentication Settings
To changeDescriptionOption
See Set Device Authentication Field,
on page 173.
Determines whether 802.1X authentication is
enabled:
•
Enabled: Phone uses 802.1X authentication
to request network access.
•
Disabled: Default setting. The phone uses
CDP to acquire VLAN and network access.
Device
Authentication
Display only. Cannot configure.State: Displays the state of 802.1x authentication:
•
Disconnected: Indicates that 802.1x
authentication is not configured on the
phone.
•
Authenticated: Indicates that the phone is
authenticated.
•
Held: Indicates that the authentication
process is in progress.
Protocol: Displays the EAP method that is used
for 802.1x authentication (can be EAP-FAST or
EAP-TLS).
Transaction Status
Set Device Authentication Field
Procedure
Step 1
Press Applications .
Step 2
Choose Admin settings > Security setup > 802.1X Authentication
Step 3
Set the Device Authentication option:
•
Yes
•
No
Step 4
Press Apply.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
173
Supported Security Features