Set Up Enable Video On/Off
The Enable Video On/Off setting improves the video conference call flow by removing the black box that is
displayed when one party has the Auto Transmit setting on their phone set to Off.
This setting works in conjunction with Auto Transmit. If the Enable Video feature is set to Off, it overrides
the Auto Transmit setting and you can send audio calls. But if Enable Video is set to On and Auto Transmit
is set to Off, the video stream is blocked and the user sends a black box to the other party. For this feature to
function, Cisco recommends Auto Transmit remains On.
The Enable Video On/Off setting functions like Video Capability: Enable/Disable on Cisco Unified
Communications Manager (Unified CM). However, the server settings override the phone settings so if video
is disabled on the Unified CM, this feature is not available on the phone and all calls are audio only.
Procedure
to be added
Set Up Dial Tone from Release Button
You can provide users with one-button access to the dial tone and the New Call window from an active call.
The following table describes the field for the Dial Tone from Release button feature.
DescriptionField
Identifies if pressing the Release key causes the user
to hear dial tone (Enabled) or not (Disabled).
The possible values are Disabled or Enabled.
The default is Disabled
Provide Dial Tone from Release Key
Procedure
Step 1
In Cisco Unified Communications Manager Administration, navigate to one of the following windows:
•
System > Enterprise Phone Configuration
•
Device > Device Settings > Common Phone Profile
•
Device > Phone > Phone Configuration
Step 2
Set the Provide Dial Tone from Release Key field.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0
228
Set Up Enable Video On/Off
To Next Page
Loading...
