Cisco 9971 - Cisco Unified Communications Manager Phone Setup; CHAPTER 5 Cisco Unified Communications Manager Phone Setup; Set up Cisco Unified IP Phone

CHAPTER 5
Cisco Unified Communications Manager Phone
Setup
•
Set Up Cisco Unified IP Phone, page 87
•
Determine the Phone MAC Address, page 90
•
Phone Addition Methods, page 91
•
Add Users to Cisco Unified Communications Manager, page 92
•
Add User to End User Group, page 94
•
Associate Phones with Users , page 94
•
Survivable Remote Site Telephony, page 95
•
Set Up Cisco Unified Communications Manager Features, page 97
Set Up Cisco Unified IP Phone
If autoregistration is not enabled and the phone does not exist in the Cisco Unified Communications Manager
database, you must configure the Cisco IP Phone in Cisco Unified Communications Manager manually. Some
tasks in this procedure are optional, depending on your system and user needs.
For more information about Cisco Unified Communications Manager Administration, see the Cisco Unified
Communications Manager Administration Guide.
Perform the configuration steps in the following procedure using Cisco Unified Communications Manager
Administration.
Procedure
Step 1
Gather the following information about the phone:
•
Phone model
•
MAC address
•
Physical location of the phone
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
87