Cisco 9971 - Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager

The following figure shows the components of the ADA Non-Lockable Wall Mount Kit for 8961 Series and
9900 Series IP Phones.
Figure 17: Components
The package contains the following items:
•
One phone bracket
•
One wall bracket
•
Four #8-18 x 1.25-inch Phillips-head screws with four anchors
•
Two #4-40 x 0.31-inch machine screws
•
One 6-inch Ethernet cable
Install Non-Lockable Wall Mount Kit for Phone
The wall mount kit can be mounted on most surfaces, including concrete, brick, and similar hard surfaces.
To mount the kit on concrete, brick, or similar hard surfaces, you must provide the appropriate screws and
anchors for your wall surface.
Before You Begin
You need these tools to install the bracket:
•
#1 and #2 Phillips-head screwdrivers
•
Level
•
Pencil
You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does not
currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular
telephone jack.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0
138
Non-Lockable Wall Mount Components for Phone