Cisco 9971 - Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager

DescriptionItem
Cause of the last reset of the phone. Specifies one of the following values:
•
Initialized
•
TCP-timeout
•
CM-closed-TCP
•
TCP-Bad-ACK
•
CM-reset-TCP
•
CM-aborted-TCP
•
CM-NAKed
•
KeepaliveTO
•
Failback
•
Phone-Keypad
•
Phone-Re-IP
•
Reset-Reset
•
Reset-Restart
•
Phone-Reg-Rej
•
Load Rejected HC
•
CM-ICMP-Unreach
•
Phone-Abort
Restart Cause
Amount of time that has elapsed since the phone last rebooted.Elapsed Time
Link state and connection of the Network port. For example, Auto 100
Mb Full-Duplex means that the Network port is in a link-up state and has
autonegotiated a full-duplex, 100-Mbps connection.
Port 1
Link state and connection of the PC port.Port 2
•
In IPv4-mode, displays only the DHCPv4 state, such as DHCP
BOUND.
•
In IPv6-mode, displays only the DHCPv6 state, such as ROUTER
ADVERTISE., (GOOD IP).
•
In dual-stack mode, both DHCPv4 and DHCPv6 state information
is displayed.
DHCP state (IPv4 / IPv6)
The following tables describe the messages that appear for DHCPv4 and DHCPv6 states.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
273
Cisco Unified IP Phone Status