EasyManuals Logo

Cisco 9971 Administration Guide

Cisco 9971
352 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #314 background imageLoading...
Page #314 background image
DescriptionItem
Total number of concealment frames divided by total number of speech frames
that were received from the start of the voice stream.
Cumulative Conceal Ratio
Ratio of concealment frames to speech frames in the preceding 3-second interval
of active speech. If voice activity detection (VAD) is in use, a longer interval
might be required to accumulate three seconds of active speech.
Interval Conceal Ratio
Highest interval concealment ratio from the start of the voice stream.Max Conceal Ratio
Score that is an objective estimate of the mean opinion score (MOS) for listening
quality (LQK) that rates from 5 (excellent) to 1 (bad). This score is based on
audible concealment events that are to frame loss in the preceding eight-second
interval of the voice stream. For more information, see Voice Quality
Monitoring, on page 330.
The MOS LQK score can vary due to the codec type that the Cisco
Unified IP Phone uses.
Note
MOS LQK
Average MOS LQK score that was observed for the entire voice stream.Avg MOS LQK
Lowest MOS LQK score that was observed from the start of the voice stream.Min MOS LQK
Baseline or highest MOS LQK score that was observed from start of the voice
stream.
These codecs provide the following maximum MOS LQK score under normal
conditions with no frame loss:
•
G.711 yields 4.5.
•
G.729 A /AB yields 3.7.
Max MOS LQK
Version of the Cisco proprietary algorithm that is used to calculate MOS LQK
scores.
MOS LQK Version
Number of seconds that have concealment events (lost frames) from the start
of the voice stream (includes severely concealed seconds).
Conceal Secs
Number of seconds that have more than five percent concealment events (lost
frames) from the start of the voice stream.
Severely Conceal Secs
Estimate of the network latency, expressed in milliseconds. Represents a running
average of the round-trip delay, measured when RTCP receiver report blocks
are received.
Latency
(see note)
Maximum value of instantaneous jitter, in milliseconds.Max Jitter
RTP packet size, in milliseconds, for the transmitted stream.Sender Size
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0
296
Cisco IP Phone Web Page

Table of Contents

Other manuals for Cisco 9971

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 9971 and is the answer not in the manual?

Cisco 9971 Specifications

General IconGeneral
Resolution640 x 480 pixels
Programmable Line Keys5
ProtocolsSIP, SCCP
Wi-Fi802.11a/b/g
Weight3.5 lbs
Display5-inch color LCD
AudioWideband audio, G.722 codec support
USB Ports2 x USB 2.0
Ethernet Ports2
PoEYes (802.3af)
VideoH.264
Network Interfaces10/100/1000 Ethernet
CodecsG.711, G.722, G.729a, G.729ab, iLBC
Power OptionsPoE
Headset PortDedicated headset port
SpeakerphoneFull-duplex speakerphone

Related product manuals