DescriptionField
Length of time that the phone is idle before the display turns off. Applies only
when the display was off as scheduled and was turned on by a user (by pressing
a button on the phone or lifting the handset).
Enter the value in this field in the format hours:minutes.
For example, to turn the display off when the phone is idle for 1 hour and 30
minutes after a user turns the display on, enter 01:30.
The default value is 01:00.
Display Idle Timeout
Step 4
Select Save.
Step 5
Select Apply Config.
Step 6
Restart the phone.
Schedule Power Save Plus (EnergyWise) on Cisco IP Phone
To reduce power consumption, configure the phone to sleep (power down) and wake (power up) if your system
includes an EnergyWise controller.
You configure settings in Cisco Unified Communications Manager Administration to enable EnergyWise and
configure sleep and wake times. These parameters are closely tied to the phone display configuration parameters.
When EnergyWise is enabled and a sleep time is set, the phone sends a request to the switch to wake it up at
the configured time. The switch returns either an acceptance or a rejection of the request. If the switch rejects
the request or if the switch does not reply, the phone does not power down. If the switch accepts the request,
the idle phone goes to sleep, thus reducing the power consumption to a predetermined level. A phone that is
not idle sets an idle timer and goes to sleep after the idle timer expires.
To wake up the phone, press Select. At the scheduled wake time, the system restores power to the phone,
waking it up.
Procedure
Step 1
From the Cisco Unified Communications Manager Administration, select Device > Phone.
Step 2
Locate the phone that you need to set up.
Step 3
Navigate to the Product Specific Configuration area and set the following fields.
•
Enable Power Save Plus
•
Phone On Time
•
Phone Off Time
•
Phone Off Idle Timeout
•
Enable Audible Alert
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0
212
Schedule Power Save Plus (EnergyWise) on Cisco IP Phone
To Next Page
Loading...
Need help?
General
