Cisco 9971 - CHAPTER 13 Phone Features and Setup; Phone Features and Setup Overview

•
Set Up Peer Firmware Sharing, page 225
•
Set Up Remote Port Configuration, page 226
•
Set Headset Sidetone Control, page 226
•
Enable Device Invoked Recording, page 227
•
Set Up Enable Video On/Off, page 228
•
Set Up Dial Tone from Release Button, page 228
•
Park Monitoring, page 229
•
Enable Actionable Incoming Call Alert, page 231
•
Enable the Call History Display Enhancement, page 232
•
Enable Call History for Shared Line, page 233
•
Set Up the Default Line Filter, page 233
•
Set Up Custom Line Filter, page 233
•
Phone Button Templates, page 234
•
Control Phone Web Page Access, page 237
•
Enable Softkey Policy Control, page 237
•
Set Up a Softkey Template, page 238
•
Set Up Separate Audio and Video Mute, page 241
•
Set Up RTP/sRTP Port Range, page 241
•
Set Up TLS Resumption Timer, page 242
•
Set Up the Audio and Video Port Range, page 242
•
Set Up Cisco IP Manager Assistant, page 244
•
Enable Privacy Settings, page 246
•
Set Up Audio EQ, page 247
•
Set the Label for a Line, page 247
Phone Features and Setup Overview
After you install Cisco Unified IP Phones in your network, configure their network settings, and add them to
Cisco Unified Communications Manager, you must use the Cisco Unified Communications Manager
Administration application to configure telephony features, optionally modify phone templates, set up services,
and assign users.
You can modify additional settings for the Cisco Unified IP Phone from Cisco Unified Communications
Manager Administration. Use this web-based application to set up phone registration criteria and calling search
spaces, to configure corporate directories and services, and to modify phone button templates, among other
tasks.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0
182
Phone Features and Setup Overview