DescriptionItem
Number of errors that the video decoder reported since the video stream
opened.
Rcvr Frame Errors
Bandwidth of the received video steam in kbps (kilo bits per second).Rcvr Bandwidth
Resolution of the video stream that the phone received from the remote
endpoint. VGA(640x480), CIF (352x288), QCIF (176x144), and so forth.
Rcvr Resolution
Time stamp that indicates when the first RTP packet is sent to the network.Sender Start Time
Time stamp that indicates when the first RTP packet is received from the
network.
Rcvr Start Time
Estimate of the network latency, expressed in milliseconds. Represents a
running average of the round-trip delay, measured when RTCP receiver report
blocks are received.
Latency
Display Current Access Point Window
The Current Access Point screen displays statistics about the current access point on the wireless Cisco Unified
IP Phone 9971. Current Access Point Fields, on page 282 describes the information that appears in this screen.
To display the Current Access Point screen, follow these steps:
Procedure
Step 1
Press Applications .
Step 2
Select Administrator Settings.
Step 3
Select Status.
Step 4
Select Current Access Point.
Step 5
To exit the Current Access Point screen, press Exit.
Current Access Point Fields
The following table describes the fields in the Current Access Point screen.
Table 42: Current Access Point Items
DescriptionItem
Name of the AP, if it is CCX-compliant; otherwise, the MAC address displays here.AP Name
MAC address of the AP.MAC Address
The latest frequency where this AP was observed.Frequency
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0
282
Cisco Unified IP Phone Status
To Next Page
Loading...
