To ChangeDescriptionOption
See Set SW Port Setup Field, on
page 80.
Speed and duplex of the network
port. Valid values specify:
•
Auto Negotiate
•
1000 Full:1000-BaseT/full
duplex
•
100 Half: 100-BaseT/half
duplex
•
100 Full: 100-BaseT/full duplex
•
10 Half: 10-BaseT/half duplex
•
10 Full: 10-BaseT/full duplex
If the phone is connected to a switch,
configure the port on the switch to
the same speed/duplex as the phone,
or configure both to autonegotiate.
If you change the setting of this
option, you must change the PC Port
Configuration option to the same
setting.
SW Port Setup
See Set PC Port Setup Field, on
page 80.
To configure the setting on multiple
phones simultaneously, enable
Remote Port Configuration in the
Enterprise Phone Configuration
window(System > Enterprise
Phone Configuration).
If the ports are configured
for Remote Port
Configuration in Cisco
Unified Communications
Manager Administration,
the data cannot be changed
on the phone.
Note
Speed and duplex of the Computer
(access) port. Valid values:
•
Auto Negotiate
•
1000 Full: 1000-BaseT/full
duplex
•
100 Half: 100-BaseT/half
duplex
•
100 Full: 100-BaseT/full duplex
•
10 Half: 10-BaseT/half duplex
•
10 Full: 10-BaseT/full duplex
If the phone is connected to a switch,
configure the port on the switch to
the same speed/duplex as the phone,
or configure both to autonegotiate.
If you change the setting of this
option, you must change the SW Port
Configuration option to the same
setting.
PC Port Setup
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0
72
Configure Network Settings
To Next Page
Loading...
Need help?
General
