To ChangeDescriptionOption
See Set Domain Name Field, on page
79.
Name of the Domain Name System (DNS)
domain in which the phone resides.
Domain Name
See Set SSID Field, on page 81.Specifies the Service Set Identifier, a unique
identifier for accessing wireless access
points.
SSID
See Set Security Mode Field, on page
81.
The type of authentication that the phone
uses to access the WLAN. Valid values
specify:
•
Open: Access to all access points (APs)
without encryption.
•
Open with WEP: Open 802.11
authentication but uses Wired
Equivalent Privacy (WEP) for
encrypting the data. Specifies access to
all APs and authentication through
WEP keys at the local AP.
•
Shared Key: Shared key authentication
using WEP.
•
LEAP: Lightweight Extensible
Authentication Protocol authentication
exchanges a username and
cryptographically secure password with
a RADIUS server in the network.
LEAP is a Cisco proprietary version of
EAP. LEAP supports WPA and WPA2.
•
EAP-FAST: Extensible Authentication
Protocol Flexible Authentication via
Secure Tunneling exchanges a
username and cryptographically secure
password with a RADIUS server in the
network where a PAC (Protected
Access Credential) establishes a secure
tunnel for authentication. EAP-FAST
supports WPA and WPA2.
•
AKM: Selects the 802.11 authentication
mechanism automatically from the
configuration information that the
access point exhibits. WPA-PSK or
WPA versions 1 or 2 can be used if
they are configured for this mode.
Security Mode
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
69
Set Up Wireless LAN
To Next Page
Loading...
Need help?
General
