Cisco 9971 - Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager

DescriptionFeature
Allows you to adjust headset sidetone levels.
This feature is only for analog
headsets.
Note
See:
• Cisco Unified Communications Manager System Guide, “Cisco Unified IP Phone” chapter
• Cisco Unified Communications Manager Administration Guide, “Setting Headset Sidetone
Controls” section
•
Set Headset Sidetone Control, on page 226
Headset Sidetone Controls
Controls the way that softkeys display in full screen video mode.Hide Softkeys in Full Screen Video
Mode
Provides flexibility with the flexibility to hide the video window. When the video is displayed,
the user sees the Hide Video softkey; when the video is hidden, the user sees the Show Video
softkey.
See Cisco Unified Communications Manager System Guide, “Cisco Unified IP Phones” chapter.
Hide Video Option
Removes the Wireless Setup option from the Network Setup menu when Wi-Fi is disabled
from the Cisco Unified Communications Manager.
This feature is supported only on the Cisco Unified IP Phone 9971.
See Cisco Unified Communications Manager Administration Guide, “Cisco Unified IP Phone
Configuration” chapter.
Hide Wi-Fi User Interface Setting
Limits the amount of time that a call can be on hold before it reverts back to the phone that
put the call on hold and alerts the user.
Reverting calls are distinguished from incoming calls by a single ring (or beep, depending on
the new call indicator setting for the line). This notification repeats at intervals if the call is
not resumed.
A call that triggers Hold Reversion also displays an animated icon in the call bubble and a
brief message on the status line.
You can configure call focus priority to favor incoming or reverting calls.
See Cisco Unified Communications Manager Features and Services Guide, “Hold Reversion”
chapter.
Hold Reversion
Enables phones with a shared line to distinguish between the local and remote lines that placed
a call on hold.
Hold Status
Allows the user to move a connected call from an active state to a held state.
No configuration required unless you want to use music on hold. See the “Music on Hold”
entry in this table for information.
See “Hold Reversion” in this table.
Hold/Resume
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0
194
Telephony Features